Accessibility navigation


Technique for micro-machining millimetre-wave rectangular waveguide

Collins, C.E., Miles, R.E., Pollard, R.D., Steenson, D.P., Digby, J.W., Parkhurst, G.M., Chamberlain, J.M., Cronin, N.J., Davies, S.R. and Bowen, J. W. (1998) Technique for micro-machining millimetre-wave rectangular waveguide. Electronics Letters, 34 (10). pp. 996-997. ISSN 0013-5194

Full text not archived in this repository.

It is advisable to refer to the publisher's version if you intend to cite from this work. See Guidance on citing.

To link to this item DOI: 10.1049/el:19980665

Abstract/Summary

A new technique is reported for micro-machining millimetre-wave rectangular waveguide components. S-parameter measurements on these structures show that they achieve lower loss than those produced using any other on-chip fabrication technique, have highly accurate dimensions, are physically robust, and are cheap and easy to manufacture.

Item Type:Article
Refereed:Yes
Divisions:Life Sciences > School of Biological Sciences > Department of Bio-Engineering
ID Code:18901
Uncontrolled Keywords:S-parameter measurements, dimensions, loss, micro-machining technique, millimetre-wave rectangular waveguide, waveguide components
Publisher:Institution of Engineering and Technology (IET)

University Staff: Request a correction | Centaur Editors: Update this record

Page navigation